Mini Cooper F55 F56 F57 LCI 2LCI Glove Box Cover | Racing Style Real Dry Carbon Fiber

In terms of material, the product is made of 100% real dry carbon fiber, which is a high-performance composite material widely used in the racing industry. Compared with ordinary wet carbon fiber or imitation carbon materials, it has obvious advantages: lower density makes the product lightweight (only 85g on average), avoiding adding extra load to the glove box; higher tensile strength and wear resistance can effectively resist daily scratches and collisions, maintaining the original appearance for a long time. The surface adopts a professional racing-style matte finish, which not only enhances the sporty visual effect but also reduces the reflection of light during driving, ensuring driving safety.

For the back adhesive part, the product selects international well-known brand 3M VHB acrylic foam adhesive, which meets the EU REACH environmental protection standard and the US FDA safety certification. This adhesive has strong bonding strength (shear strength up to 15MPa) and excellent environmental adaptability - it can maintain stable adhesion in the temperature range of -40℃ to 120℃, adapting to the extreme temperature changes inside the vehicle in winter and summer. At the same time, it has good water resistance and aging resistance, avoiding the problem of adhesive failure and falling off caused by long-term use in a humid environment.

The installation process is extremely simple and suitable for DIY operation without professional tools or modification. Step 1: Clean the surface of the glove box with the attached alcohol wipe to remove oil, dust and other impurities, and let it dry naturally (about 1 minute). Step 2: Tear off the protective film of the back adhesive, align the product with the edge of the glove box (the product is precision-machined according to the original OEM data of Mini Cooper, with a fitting accuracy of ±0.1mm, ensuring perfect alignment). Step 3: Press the product evenly with your palm for 30 seconds, focusing on pressing the edge positions to ensure full contact between the adhesive and the glove box surface. Step 4: Avoid touching or washing the product within 24 hours after installation to ensure the adhesive fully cures and forms a permanent bond. The entire installation process takes no more than 5 minutes.